IKEA HB M4 Instrucciones de uso descargar pdf (Pagina 9)

ENGLISH 9

Installation and electrical connection

WARNING. Disconnect the appliance

from the mains power supply.

- The appliance must be installed by a

qualied technician who is fully aware of

current safety and installation regulations.

- The manufacturer declines all liability

for injury to persons or animals and for

damage to property resulting from failure

to observe the regulations provided in this

chapter.

- The power supply cable must be long

enough to allow the hob to be removed

from the worktop.

- Make sure the voltage specied on the

appliance rating plate is the same as that of

the domestic power supply voltage.

- Do not use extension cables.

Connecting to the terminal board

For electrical connection, use an H05RR-F

cable as specied in the table below.

Conductors Amount x size

230 V ~ +

3 X 2.5 mm

2

230-240 V ~ +

3 X 2.5 mm

2

(Australia only)

230 V3 ~ +

4 X 1.5 mm

2

400 V 3N ~ +

5 X 1.5 mm

2

400 V 2N ~ +

4 X 1.5 mm

2

The connection can be made directly to the

mains by means of an all-pole disconnect

switch with minimum contact gap of 3 mm.

Important: the power supply cable must be

long enough to allow the hob to be removed

from the worktop and must be positioned so

as to avoid damage or overheating caused

by contact with the base.

Note: the yellow/green earth wire must be

connected to the terminal with the symbol

and must be longer than the other wires.

• Strip approx. 70 mm of sheath from the

power supply cable (B).

• Strip approx. 10 mm of sheath from the

wires. Next insert the power supply

cable into the cable clamp and connect

the wires to the terminal board as

indicated in the diagram next to the

terminal board itself.

• Secure the power supply cable (B) by

means of the cable clamp.

• Close the terminal board with the cover

(A) securing it with the screw provided.

• After the electrical connection, t the

hob from the top and hook it to the

support springs, following the diagram.

Each time the cooktop is connected to the

mains it carries out an automatic check

which lasts several seconds.

If the hob already has a power cable, follow

the instructions given on the label attached

to the cable. Connect the appliance to the

electricity supply by means of an all-pole

disconnect switch with minimum contact gap

of 3 mm.

A

B

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 55 56

Comentarios a estos manuales

Sin comentarios