IKEA HO EV W Instrucciones de uso descargar pdf (Pagina 8)

ENGLISH 8

Extraction speed (power) selection is cyclic

according to the speed sequence

therefore every time the “extraction power

selection” button is pressed, the extraction

speed (power) increases by one level

and switches off (Stand-by) if the button

is touched again when the hood is on

extraction speed (power) 4.

Note: Extraction speed (power) 4 remains

on for 5 minutes, after which the extraction

motor switches to speed 2.

By pressing it again the extraction motor

switches off (Stand-by).

The hood can also be switched off (Stand-

by) when it is on any speed, by prolonged

pressing (more than 3 seconds) of the

button.

The control panel has a led that changes

colour according to the extraction speed

(power), therefore hood extraction speed

(power) can be determined as follows:

Hood on stand-by: LED OFF

extraction speed

(power) 1: Led GREEN

extraction speed

(power) 2: Led ORANGE (amber)

extraction speed

(power) 3: Led RED

extraction speed

(power) 4: Led RED FLASHING

Controlofbottomlamps

The bottom light can be switched on or off

by pressing the “light button”.

Controlofinsidelamps

The inside lights can be switched on or

off by PROLONGED pressing of the “light

button”.

As well as as switching on and off,

PROLONGED PRESSING also allows the

brightness of the lamps to be adjusted.

Note: the switching on and off (and

adjustment) functions alternate.

Reset and conguration of lter saturation

signalling

Switch the hood on at any speed (see

section above “Extraction speed (power)

control”)

Resetgreaseltersaturationsignalling

(GREENLEDFLASHINGoncontrolpanel)

Firstly carry out lter maintenance as

described in the relevant section.

Press (prolonged for more than 3 seconds)

the “extraction power selection” button; the

LED stops ashing to indicate that

signalling has been reset, and the hood

switches off.

Resetcarbonltersaturationsignalling

(ORANGE(amber)LEDFLASHING)

Firstly carry out lter maintenance as

described in the relevant section.

Press (prolonged for more than 3 seconds)

the “extraction power selection” button; the

LED stops ashing to indicate that

signalling has been reset, and the hood

switches off.

Deactivationofcharcoalltersaturation

signalling(forparticularapplications)

Switch off the hood (see section above

“Extraction speed (power) control”)

Press (prolonged for more than 5 seconds)

the “extraction power selection” button; the

LED ashes GREEN (amber) to

indicate that carbon lter saturation

signalling has been deactivated.

To reactivate charcoal lter saturation

signalling, repeat the operation, and the

LED will ash ORANGE.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 59 60

Comentarios a estos manuales

Sin comentarios