IKEA MHGC2K Manual de usuario descargar pdf (Pagina 9)

Removing the residues and stubborn

residues:

1. Food containing sugar, plastics, tin foil

residues should be removed at once,

best tool for cleaning glass surface is a

scraper (not included with the appli-

ance). Place a scraper on the glass ce-

ramic surface at an angle and remove

residues by sliding the blade over the

surface. Wipe the appliance with a

damp cloth and a little washing up liq-

uid. Finally, rub the appliance dry using

a clean cloth.

2. Limescale rings, water rings, fat

splashes, shiny metallic discolorations

should be removed after the appliance

has cooled down using cleaner for

glass ceramic or stainless steel.

What to do if…

Problem Possible cause Remedy

The cooking zones will

not switch on or are not

functioning.

More than 10 seconds passed

since you switched on the hob.

Switch the appliance on again.

The child safety device or the

Lock is on

.

Deactivate the child safety de-

vice (See the sections “Child

safety device ” or “Lock”).

Several sensor fields were

touched at the same time.

Only touch one sensor field.

Acoustic signal sounds,

appliance switches off.

One or more sensor fields have

been covered for longer than

10 seconds.

Uncover sensor field.

The residual heat indi-

cator is not displaying

anything.

The cooking zone was only on

for a short time and is there-

fore not hot.

If the cooking zone is supposed

to be hot, call the After Sales

Service.

symbol plus a num-

ber appears on the

heat setting display.

Electronics fault. Disconnect the appliance from

the electrical supply for a few

minutes (Take the fuse out of

the house’s electric system) If

after switching on again,

is

displayed again, call the cus-

tomer service department.

If there is a fault, first try to find a solution to

the problem yourself. If you cannot find a

solution to the problem yourself, contact

your dealer or the After Sales Service.

If you operated the appliance wrongly,

or the installation was not carried out

by a registered engineer, the visit from the

customer service technician or dealer may

not take place free of charge, even during

the warranty period.

ENGLISH 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 59 60

Comentarios a estos manuales

Sin comentarios