IKEA MHGC2K Manual de usuario descargar pdf (Pagina 11)

Protect the cut surfaces of the worktop

against moisture using a suitable sealant in-

cluded in the product in fitting bag. The

sealant seals the appliance to the work top

with no gap. Do not use silicon sealant be-

tween the appliance and the worktop.

Avoid installing the appliance next to doors

and under windows as hot cookware may

be knocked off the rings when doors and

windows are opened.

Only an authorized service engineer can in-

stall, connect or repair this appliance. Use

only original spare parts.

Electrical connection

Before connecting, check that the nominal

voltage of the appliance stated on the rat-

ing plate, corresponds to the available sup-

ply voltage. Also, check the power rating of

the appliance and ensure that the wire is

suitably sized to suit the appliance power

rating (refer to the Technical data chapter).

The rating plate is located on the lower cas-

ing of the hob.

The appliance is supplied with a connection

cable. This has to be provided with a prop-

er plug, able to support the load marked on

the identification plate. To connect the plug

to the cable, follow the recommendation

given in following figure.

1

2

Replacement of the connection cable

The replacement of the connection cable

requires the specific equipment of a techni-

cian. Only an original spare part able must

be used, provided by spare parts service.

The plug has to be fitted in a proper socket.

If connecting the appliance directly to the

electric system, it is necessary that you in-

stall a double pole switch between the ap-

pliance and the electricity supply, with a

minimum gap of 3 mm. between the switch

contacts and of a type suitable for the re-

quired load in compliance with the current

rules.

The connection cable has to be placed in

order that, in each part, it cannot reach a

temperature 90 °C higher than the room

temperature. The brown (or black) phase

cable (fitted in the terminal block contact

marked with "L") must always be connected

to the network phase.

Warning! Once connected to the

mains supply check that all cooking

zones are ready for use by briefly setting

each to maximum power.

ENGLISH 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 59 60

Comentarios a estos manuales

Sin comentarios