IKEA LAGAN-N Manual de usuario descargar pdf (Pagina 17)

The appliance must be connected to a

220-240 V 50/60 Hz AC electrical supply.

Before activating the appliance, make sure

the electrical supply voltage is the same as

that indicated on the rating plate. The

rating plate is located below the surface of

the casing.

The appliance is supplied with a 3 core

flexible supply cord requiring a 3 amp plug.

You must install the plug. The wires in the

mains lead are coloured in accordance with

the following code:

Green and yellow - Earth

Blue - Neutral

Brown - Live

1. Connect the green and yellow (earth)

wire to the terminal in the plug which is

marked with the letter 'E' or the earth

symbol

, or coloured green and

yellow.

2. Connect the blue (neutral) wire to the

terminal in the plug which is marked

with the letter 'N' or coloured black.

3. Connect the brown (live) wire to the

terminal in the plug which is marked

with the letter 'L' or coloured red.

There must be no cut or stray strands of

wire present. The cord clamp must be

correctly attached on the outer sheath.

Warning! Be careful when you

dispose of the cut off plug. It is

dangerous to put a cut off plug

into a 13 amp socket. There is a

risk of electrical shock.

Only a qualified electrician can

replace the electrical cable,

according to the current

regulations.

Replacement of the connection cable

Warning! To replace the

connection cable, the technician

must have a specific equipment.

In this case, only cable type H03V2V2-F

T90 must be used. The cable section must

be suitable to the voltage and the working

temperature. The yellow and green earth

wire

2

must be approximately 2 cm longer

than the brown or black phase wire

1

.

1

2

Gas connection

Warning! Refer to Safety

chapters.

Caution! Information for

authorised installer only.

ENGLISH 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Comentarios a estos manuales

Sin comentarios