IKEA MHGA2K Manual de usuario descargar pdf (Pagina 16)

The replacement of the electrical

cable must be done by a

qualified electrician or

competent person, according to

the current regulations.

Replacement of the connection cable

Warning! The replacement of

electric cable must be carried out

exclusively by the After Sales

Service or by personnel with

similar competencies, in

accordance with the current

regulations.

If the connection cable must be replaced,

only a type H05V2V2-F T90 cable must be

used. The cable section must be suitable to

the voltage and the working temperature.

The yellow/green earth wire must be

approximately 2 cm longer than the brown

(or black) phase wire.

Gas setting conversion

This model is designed for use

with natural gas but can be

converted for use with butane or

propane gas providing the

correct injectors. The injectors not

supplied with the appliance have

to be ordered from After Sales

Service (refer to the Service

chapter).

For data concerning injector replacement,

refer to the chapter Technical data.

Warning! Conversion or

replacement can only be

performed by a registered

installer.

To replace injectors:

1. Remove pan support.

2. Remove burner cap and crown.

3. With a socket spanner 7 unscrew and

remove the injectors, replace them with

the ones required for the type of gas in

use.

4. Reassemble the parts, following the

same procedure backwards.

Place the label with relevant

information for new type of gas

close to the supply pipe before

sealing the appliance. If the

appliance is already sealed

please stick it directly on the user

manual booklet after Technical

data chapter close to the rating

plate drawing.

You can find this label in

package supplied with

appliance.

If the feeding gas pressure will

be different or variable,

comparing with the required, you

must install an appropriate

pressure adjuster, which is not

supplied with the product and if

needed must be ordered

separately from the local After

Sales Service (refer to the Service

chapter). The pressure adjuster

must be fitted on gas supply

pipe, in compliance with the rules

of the force.

The rating plate is located on the lower

casing of the hob.

Adjusting flame level

When hob has been fully installed, it is

necessary to check the minimum flame

setting:

1. Turn the gas tap to the maximum

position and ignite.

ENGLISH

16

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios