IKEA MHGA2K Manual de usuario descargar pdf (Pagina 15)

Installation must comply with current local

regulation. The connection of the cooktop to

the gas pipe network or gas cylinder must

be made by means of a rigid copper or

steel pipe with fittings complying with local

regulations, or by means of a continuous

surface stainless steel hose complying with

local regulations.

If you see any abnormalities do

not repair the pipe, contact local

After Sales Service (refer to the

Service chapter).

The connection must be installed correctly,

fixed into hob connection pipe. Otherwise it

will cause leakage of gas.

Warning! Once the installation is

complete, check the perfect seal

of every pipe fixing. Use soapy

water, never flame.

Electrical connection

The electrical work necessary to install the

appliance must be done by a qualified

electrician or competent person, according

to the current regulations.

Before connecting, check that the nominal

voltage of the appliance stated on the

rating plate, corresponds to the available

supply voltage. Also, check the power

rating of the appliance and ensure that the

wire is suitably sized to suit the appliance

power rating (refer to the Technical data

chapter).

Electrical Requirements

Permanent electrical installation must

comply with the latest I.E.E. Regulations and

local Electricity Board regulations. For your

own safety the installation must be done by

a qualified electrician (e.g. your local

Electricity Board, or a contractor who is on

the roll of the National Inspection Council

for Electrical Installation Contracting

[NICEIC]).

The manufacturer declines any

liability if these safety measures

are not observed.

The appliance must be connected to a

220-240 V 50/60 Hz AC electrical supply.

Before activating the appliance, make sure

the electrical supply voltage is the same as

that indicated on the rating plate. The

rating plate is located on the bottom of the

appliance.

The appliance is supplied with a 3 core

flexible supply cord requiring a 3 amp plug.

You must obtain and install the plug. The

wires in the mains lead are coloured in

accordance with the following code:

Green and yellow - Earth

Blue - Neutral

Brown - Live

1. Connect the green and yellow (earth)

wire to the terminal in the plug which is

marked with the letter 'E' or the earth

symbol

, or coloured green and

yellow.

2. Connect the blue (neutral) wire to the

terminal in the plug which is marked

with the letter 'N' or coloured black.

3. Connect the brown (live) wire to the

terminal in the plug which is marked

with the letter 'L' or coloured red.

There must be no cut or stray strands of

wire present. The cord clamp must be

correctly attached on the outer sheath.

Warning! Make sure that the cut

off plug is disposed of safely. A

cut off plug put into a 13 amp

socket is a safety hazard. There

is a risk of electrical shock.

ENGLISH 15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Comentarios a estos manuales

Sin comentarios