IKEA MHGA2K Manual de usuario descargar pdf (Pagina 13)

Important! Replace the rating label (placed

near gas supply pipe) with relevant one for

the new type of gas supply before sealing

the appliance. If the appliance is already

sealed please stick it directly on the user

manual booklet after Technical data

chapter close to the rating plate drawing.

You can find this label in package sup-

plied with appliance

If the feeding gas pressure will be dif-

ferent or variable, comparing with the

required, you must install an appropriate

pressure adjuster, which is not supplied with

the product and if needed must be ordered

separately from the local After Sales Service

(refer to the Service chapter). The pressure

adjuster must be fitted on gas supply pipe,

in compliance with the rules of the force.

The rating plate is located on the lower cas-

ing of the hob.

Conversion to G2.350 gas

• Auxiliary and semi-rapid burner: after

you assembly the injectors (

3

in follow-

ing figure), screw their cages (diameter

10 mm,

1

in following figure) on, inclu-

ded in the supply (primary air regula-

tors) ;

• Rapid burner: after assembly the injectors

(

3

in following figure), screw their cages

(diameter 16 mm,

2

in following figure)

on, included in the supply (primary air

regulators) ;

1

2

4

3

Important! In both cases use the special

cap tool

4

and a screwdriver to secure the

cages.

Important! Be sure to remove the cap tool

before reassembling the burners.

Adjusting flame level

When hob has been fully installed, it is nec-

essary to check the minimum flame setting:

1. Turn the gas tap to the maximum posi-

tion and ignite.

2. Set the gas tap to the minimum flame

position then turn the control knob from

minimum to maximum several times. If

the flame is unstable or extinguished,

follow the procedure further.

3. Re-ignite the burner and set to mini-

mum.

4. Remove the control knob.

5. To adjust, use a thin bladed screwdriver

and turn the adjustment screw until the

flame is steady and does not extin-

guish, when the knob is turned from

minimum to maximum, and vice versa

(see following picture).

ENGLISH 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Comentarios a estos manuales

Sin comentarios