IKEA LAGAN-N Manual de usuario descargar pdf (Pagina 16)

The minimum distance to be maintained

from cut out edge to lateral wall must be

100 mm.

If there is no oven beneath the hob insert a

dividing panel at a minimum distance of 5

mm from the bottom of the hob.

Protect the cut surfaces of the worktop

against moisture using a suitable sealant

included in the product in additional bag.

Seal the appliance to the worktop with no

gap. Do not use silicon sealant between the

appliance and the worktop. Do not install

the appliance next to the doors and under

windows. Otherwise, the hot cookware may

fall off the pan supports.

Electrical connection

Warning! Refer to Safety

chapters.

Connection cable

Caution! Information for

authorised installer only.

Warning!

The appliance must be earthed.

Warning!

Risk of injury from electrical

current.

• The electrical mains terminal is under

voltage.

• Make sure that the electrical mains

terminal is free of voltage.

• Loose and inappropriate plug and

socket connections. May overheat the

terminal.

• Make sure that the clamping connections

are installed correctly.

• Secure the cable with the strain relief

clamp.

Before connecting, check that the nominal

voltage of the appliance stated on the

rating plate, corresponds to the available

supply voltage. Also, check the power

rating of the appliance and make sure that

the wire is suitably sized to suit the

appliance power rating. Refer to the

Technical data chapter.

The rating plate is located below the

surface of the casing.

The appliance is supplied with a connection

cable. The cable must be provided with a

proper plug, which supports the load

marked on the identification plate. Refer to

the Technical data chapter.

The plug has to be fitted in a proper socket.

If connecting the appliance directly to the

electric system, it is necessary that you

install a double pole switch between the

appliance and the electricity supply, with a

minimum gap of 3 mm between the switch

contacts. The double pole has to be of a

type suitable for the required load in

compliance with the current rules.

The connection cable has to be placed in

order that, in each part, it cannot reach a

90 °C temperature. The blue neutral cable

must be connected to the terminal block

marked with "N". The brown or black phase

cable, fitted in the terminal block contact

marked with "L", must always be connected

to the live phase.

ENGLISH 16

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 47 48

Comentarios a estos manuales

Sin comentarios